1-1. Attaching the 4-type or 5-type
Viewfinder
An optional 4-type viewfinder (DXF-40 series) or 5-type
viewfinder (DXF-50 series) can be attached in accordance
with the following procedures:
Parts Required (available separately)
Name
Shoe
Plate spring
Stop screw
Screw K3 x 12 (4 pcs)
Conversion cable (8pin-20pin)
*1 This conversion cable is not required for DXF-51.
Attaching Procedure
1. Remove the one screw (B3 x 8) and remove the handle
cover (4).
2. Tighten the shoe with four screws (K3 x 12).
3. Fix the plate spring with the stop screw.
4. Fit the guide plate in the shoe and tighten the fixing
ring.
5. Connect the cable as shown in the figure. (except
DXF-51)
DSR-570WS/570WSP V1
Section 1
Optional Accesories Installation
Sony Part No.
3-664-218-0X
3-664-228-0X
3-664-213-0X
7-682-250-04
*1
1-783-665-11
Screw
B3 x 8
Handle
cover(4)
Stop screw
Plate spring
Screws
K3 x 12
Shoe
VF connection cable
Shoe
(8pin-26pin)
Stop screw
Fixing ring
Guide plate
Screws
K3 x 12
8pin
20pin
VF conversion
cable (8pin-20pin)
1-1