Table of Contents
Advertisement
6-27. Replacement of Mode Gear
Assembly
Reel table position: Standard cassette position
Replacement Flowchart
Removal of sensor attachment plate assembly
Removal of TR band assembly
Removal of TR arm assembly
Removal of cam gear
Removal of HC gear
Replacement of soft brake arm (S)
Replacement of hard brake arm (S)
Replacement of release cam gear
Replacement of mode gear assembly
Inserting hole for reference pin
HC gear
Mode gear
Inserting hole for reference pin
6-36
TG-2 guide height check/adjustment
Tracking adjustment
Check after tracking adjustment
Check of self-recording tape playback
Removal
1. Remove the sensor attachment plate assembly.
(Refer to Section 6-15.)
2. Remove the TR band assembly. (Refer to Section 6-12.)
3. Remove the TR arm assembly. (Refer to Section 6-16.)
4. Rotate No. 1 gear in the counterclockwise direction to set it in
the unthreading condition.
5. Insert the reference pin at the position shown in the figure, and
adjust the phase of each gear.
6. Remove the cam gear.
7. Remove the HC gear.
8. Remove the soft brake arm (S). (Refer to Section 6-16.)
9. Remove the hard brake arm (S). (Refer to Section 6-7.)
10. Remove the release cam gear.
Shaft a should be seen.
Long hole
Cam gear
Threading gear
Release cam gear
Phase mark
Protrusion
Teeth A
Part B
GL (S) assembly
V groove
GL (T) assembly
DSR-570WS/570WSP V1
Hide quick links:
Advertisement
Table of Contents
