Sony DSR-570WS Service Manual page 101

4-2-3. Service Menu
. . . . . Page 1 RESET
(For DSR-570WS)
PAGE1 (NEXT PREV
RESET
(YES PUSH)
DEST : UC
ROM VER : ***
EXIT MENU (YES PUSH)
(For DSR-570WSP)
PAGE1 (NEXT PREV
RESET
(YES PUSH)
ROM VER : ***
EXIT MENU (YES PUSH)
. . . . . Page 2 Shading Correction
PAGE2 (NEXT PREV
EXTENDER OFF
AUTO SHAD
(YES PUSH)
:
R W. SHAD 128
:
G W. SHAD 128
B W. SHAD : 128
EXIT MENU (YES PUSH)
. . . . . Page 3 Flare Adjustment
PAGE3 (NEXT PREV
R FLARE : 0
G FLARE : 0
B FLARE : 0
EXIT MENU (YES PUSH)
DSR-570WS/570WSP V1
All adjusting values with electronic volume control of each board that are
)
unit-independent can be restored to their standard setting values. (Refer to
Section 4-2-2.)
* Move the cursor to "DEST" position, select "UC," then move the cursor
to "RESET," and then press the MENU dial.
* Move the cursor to "RESET," and then press the MENU dial.
)
EXTENDER
)
AUTO SHAD
R W.SHAD/G W.SHAD/B W.SHAD
The shading correction data in this page are stored to eight memories that
correspond to lenses 1, 2, 3 and 4 for EXTENDER ON and for EXTEND-
ER OFF respectively. The lens number corresponds LENS SEL in page 4 of
the ADVANCED menu.
R W. SHAD, G W. SHAD and B W. SHAD set the correction value
correspond to setting of LENS SEL and EXTENDER ON/OFF.
For details, refer to "Adjusting the Lens " in Chapter 5 "Adjustments and
Settings" of the Operating Instructions.
R FLARE/G FLARE/B FLARE
)
Current extender status display
Performing of auto shading correction
White shading correction of V
Standard (correcton 0) = 128
Flare correction
(0 = no correction)
4-15