Sony DSR-570WS Service Manual page 177

13. Place the torque gauge on the S reel table, press
the STOP key, and rotate the reel table towards
the REV side.
14. Adjust the torque gauge pointer to "0" and check
that the torque gauge value satisfies the
specification.
Specification:
REV rewinding torque: 0.0052 ± 0.0002 N.m
If it does not, perform the following adjustment.
. When the torque value is towards the + side:
Press the REW key and adjust so that the
torque value is within the specification.
. When the torque value is towards the _ side:
Press the FF key and adjust so that the torque
value is within the specification.
15. Press the STOP key, and stop the reel table from
rotating.
16. After removing the torque gauge, press the
EJECT key, and check that the display windows
is as shown in the figure.
17. Attach the cassette compartment.
(Refer to Section 6-2.)
18. While pressing the SHIFT button inside the TC
panel, press the MENU button.
19. While pressing MENU button, release the SHIFT
button. Check that "600 oFF" is displayed about
1 second later, and release the MENU button.
(Displayed characters underlined in the
following description indicate that they are
blinking.)
20. Press the RESET (MENU SET) button once to
blink "oFF."
21. Press the ADVANCE button once and select
"on." (on and oFF are repeated each time the
ADVANCE button is pressed.)
22. Press the RESET (MENU SET) button once.
23. Press the ADVANCE button or SHIFT button to
display Menu No. 609.
DSR-570WS/570WSP V1
(52 ± 2 g.cm)
Torque gauge
S reel table
6-59