Figure 54: Console And Auxiliary Serial Port Connector - Juniper M10i Hardware Manual

M10i Internet Router Hardware Guide
2.
3.
4.

Figure 54: Console and Auxiliary Serial Port Connector

132
Replacing Routing Engine Components
Pull the cable connector straight out of the port.
c.
Disconnect the cable from the console or auxiliary device.
d.
Plug the female end of the replacement serial cable into the appropriate
or port.
AUX/MODEM Figure 52
Engine.
Tighten the screws on the connector, using a 2.5-mm flat-blade screwdriver if
necessary.
Power on the auxiliary or console device.
shows the external device ports on the Routing
CONSOLE