M10i Internet Router Hardware Guide
Figure 50: Inserting the Internal Flash Drive
Configuring the Internal Compact Flash Disk
After installing the internal compact flash disk for the first time, you must copy the
software from the Routing Engine's hard disk to the internal compact flash disk.
To copy software to the compact flash disk, perform the following procedure:
1.
2.
3.
128
Replacing Routing Engine Components
Install the internal compact flash disk and replace the Routing Engine as described
in
"Inserting the Internal Compact Flash Disk"
Engine"
on page 123.
On the console or other management device connected to the Routing Engine,
enter CLI operational mode and issue the following command to copy the
currently running and active file system partitions on the router to standby
partitions on the internal compact flash disk.
user@host> request system snapshot partition
Wait until a message appears on the console confirming that the procedure is
complete.
For more information about the command, see the JUNOS System Basics and
Services Command Reference.
Issue the following command to reboot the router's software:
user@host> request system reboot
on page 127 and
"Installing a Routing