Chapter 6 Unpacking The Router; Tools And Parts Required - Juniper M10i Hardware Manual

Chapter 6
Unpacking the Router

Tools and Parts Required

Unpacking the Router
This chapter explains how to unpack the router and verify the parts received. It also
describes how to move the mounting brackets and install the cable management
system. Before beginning, prepare the installation site as described in "Preparing for
on page 41 and review the safety information in "Safety and
Router Installation"
Regulatory Compliance Information"
on page 137 and "Installation Safety Guidelines and Warnings" on page 153.
and Warnings"
This chapter discusses the following topics:
Tools and Parts Required
Unpacking the Router
To unpack the router and prepare for installation, you need the following tools:
Utility knife for cutting the sealing tape on the shipping carton
Phillips (+) screwdriver, number 2
The router is shipped in a cardboard carton, held in place with foam packing material.
The crate also contains an accessory box, the front-mounting shelf, and the M10i
Internet Router Installation Quick Start.
NOTE: The router is maximally protected inside the shipping carton. Do not unpack
it until you are ready to begin installation.
To unpack the router, perform these steps:
Move the shipping carton to a staging area as close to the installation site as
1.
possible.
Position the carton so that the arrows are pointing up.
2.
Using a utility knife, cut through the sealing tape on the top seam of the carton.
3.
Open the top flaps of the carton.
on page 135, especially "General Safety Guidelines
on page 47
on page 47
Tools and Parts Required
47