Dc Power, Connection, And Cable Specifications; Figure 56: Ac Plug Types; Table 21: Ac Power Cord Specifications - Juniper M10i Hardware Manual

Table 21
power cord provided for each country or region.

Table 21: AC Power Cord Specifications

Country
Australia
Europe (except Italy and United Kingdom)
Italy
Japan
North America
United Kingdom

Figure 56: AC Plug Types

NOTE: Power cords and cables must not block access to router components or drape
where people could trip on them.
For information about the AC power supply, including electrical specifications and
a description of components, see
connecting the power cord and grounding cable during initial installation, see
"Connecting Power to an AC-Powered Router"
the AC power cord, see

DC Power, Connection, and Cable Specifications

The DC power supplies in slots
power feeds derived from feed A, and the DC power supplies in slots
3
provides the commonly deployed
distribute DC power through a main conduit that leads to frame-mounted DC power
distribution panels, one of which might be located at the top of the rack that houses
the router. A pair of cables (one input and one return) connects the field-wiring
terminals to the power distribution panel.
on page 179 provides specifications and
"Disconnecting and Connecting AC Power"
must be powered by dedicated power feeds derived from feed B. This configuration
Appendix C: Power Requirements, Guidelines, and Specifications
Figure 56
Electrical Specification
240 VAC, 50 Hz AC
220 or 230 VAC, 50 Hz AC
230 VAC, 50 Hz AC
110 VAC, 50 or 60 Hz AC
120 VAC, 60 Hz AC
240 VAC, 50 Hz AC
"AC Power Supply" on page 20. For instructions on
on page 62. For instructions on replacing
P/S 0 and P/S 1 must be powered by dedicated
feed redundancy for the system. Most sites
A/B
Power Guidelines, Requirements, and Specifications
depicts the plug on the AC
Plug Type
SAA/3
CEE 7/7
CEI 23-16
JIS 8303
NEMA 5-15P
BS89/10
on page 110.
and
P/S 2 P/S
179