Replacing The Management Ethernet Cable; Replacing The Console Or Auxiliary Cable; Figure 53: Routing Engine Ethernet Cable Connector - Juniper M10i Hardware Manual

Replacing the Management Ethernet Cable

Replacing the Console or Auxiliary Cable

Replacing the Management Ethernet Cable
To connect the Routing Engine to a network for out-of-band management, connect
an Ethernet cable with RJ-45/RJ-45 connectors to the
Engine. One such cable is provided with the router. For cable specifications, see
"Cable Specifications for Routing Engine Management Interfaces"
this procedure:
1. If a cable is already installed in the
perform the following steps:
Press the tab on the connector and pull the connector straight out of the
a.
port. Figure 53 shows the connector.
Disconnect the cable from the network device.
b.
Plug one end of the replacement Ethernet cable into the appropriate
2.
shows the external device ports on the Routing Engine.
Figure 52
Plug the other end of the cable into the network device.
3.

Figure 53: Routing Engine Ethernet Cable Connector

Replacing the Console or Auxiliary Cable
To use a system console to configure and manage the Routing Engine, connect it to
the appropriate
CONSOLE
other auxiliary device, connect it to the appropriate
Engine. Both ports accept an RS-232 (EIA-232) serial cable with DB-9/DB-9 connectors.
One such cable is provided with the router. If you want to connect a device to both
ports, you must supply another cable. For cable specifications, see
for Routing Engine Management Interfaces"
To connect a management console or auxiliary device, follow this procedure:
1. If a cable is already installed in the
following steps:
Turn off the power to the console or auxiliary device.
a.
Unscrew the screws that secure the cable connector to the port, using a
b.
2.5-mm flat-blade screwdriver if necessary.
Chapter 13: Replacing Hardware Components
on page 131
on page 131
MGMT port for the relevant Routing Engine,
port on the Routing Engine. To use a laptop, modem, or
AUX/MODEM
on page 187.
CONSOLE or
Replacing Routing Engine Components
port on the Routing
MGMT
on page 187. Follow
MGMT
port on the Routing
"Cable Specifications
AUX/MODEM port, perform the
port.
131