M10i Internet Router Hardware Guide
14.
Figure 44: Connecting Power Cables to a DC Power Supply
Replacing Routing Engine Components
For instructions on replacing Routing Engine components, see the following sections:
120
Replacing Routing Engine Components
If the LEDs are not lit in the appropriate pattern after 60 seconds, repeat the
power supply and cable installation procedures described in
Power Supply"
on page 114 and the previous steps in this section.
On the external management device connected to the Routing Engine, monitor
the startup process to verify that the system has booted properly.
Replacing the Routing Engine
Removing and Inserting the PC Card
Removing and Inserting the Internal Flash Drive
Removing and Inserting SDRAM Modules
Replacing Connectors to Routing Engine Interface Ports
on page 121
on page 124
on page 126
on page 129
on page 130
"Installing a DC