Installing An Ac Power Supply; Figure 39: Removing An Ac Power Supply - Juniper M10i Hardware Manual

Figure 39: Removing an AC Power Supply

Installing an AC Power Supply

To install an AC power supply, follow this procedure (see
Verify that the switch on the power supply faceplate is in the
1.
Locate the power cord shipped with the router, which should be appropriate for
2.
your geographical location (see
on page 178).
Specifications"
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
3.
connect the strap to one of the ESD points on the chassis. Make sure the router
is attached to a proper earth ground. For more information about ESD, see
"Preventing Electrostatic Discharge Damage"
Grasp the handle on the power supply faceplate with one hand and place the
4.
other hand under the supply to support it.
Align the rear of the supply with the slide guides inside the chassis and slide the
5.
supply into the chassis until it contacts the midplane.
Tighten (but do not overtighten) the thumbscrews on the power supply faceplate.
6.
Insert the appliance coupler end of the power cord into the appliance inlet on
7.
the power supply faceplate and insert the plug into an AC power source
Chapter 13: Replacing Hardware Components
Figure 40
"AC Power, Connection, and Power Cord
on page 140.
Replacing Power System Components
):
( ) position.
OFF O
109