M160 Internet Router Hardware Guide
Figure 78: Removing the Rear Upper Impeller Assembly
Installing the Rear Upper Impeller Assembly
To install the rear upper impeller assembly, follow this procedure (see Figure 79
and Figure 80, which show the two types of impeller that can be installed):
1.
2.
3.
Figure 79: Installing the Rear Upper Impeller Assembly
158
Replacing Cooling System Components
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. Make sure the router
is attached to a proper earth ground. For more information about ESD, see
"Preventing Electrostatic Discharge Damage" on page 226.
Slide the assembly all the way into the chassis.
Tighten the thumbscrew at each corner of the impeller cover.