M160 Internet Router Hardware Guide
5.
6.
7.
8.
Figure 46: Reinstalling an FPC
Ejector
levers
Reinstalling the Fan Tray
The fan tray, which includes the cable management system, is located on
the front of the chassis, just above the air filter, as shown in Figure 1. To
reinstall it, follow this procedure (see Figure 47):
102
Reinstalling Components into the Chassis
Align the rear bottom corners of the FPC with the guides at the bottom of the
FPC slot. Slide the FPC into the card cage until it contacts the midplane.
Push the ends of the ejector levers inward until they are nearly flush with
the face of the FPC.
Tighten the thumbscrew at each end of the FPC to seat the FPC securely
in the chassis.
Repeat the procedure for each FPC, proceeding from left to right through the
slots with offline buttons labeled
through
on the craft interface.
FPC1
FPC7