Fpc Components - Juniper Internet Router M160 Hardware Manual

M160 Internet Router Hardware Guide

FPC Components

An FPC has the following components:
NOTE: For specific information about FPC components (for example, the amount of
memory available), issue the
16
Packet Forwarding Engine
FPC card carrier—Houses the ASICs, connectors, and processor subsystem.
Four I/O Manager ASICs—Parse Layer 2 and Layer 3 data and perform
encapsulation and segmentation. The I/O Manager ASICs divide incoming
packets into 64-byte data cells for easier processing, and reassemble the cells
for each packet after the forwarding decision is made for it. Enhanced FPCs
have I/O Manager ASICs capable of enhanced quality of service.
Two Packet Director ASICs—Transfer packets between the PICs and the I/O
Manager ASICs: one directs incoming packets from the PICs to the I/O
Manager ASICs, while the second directs outgoing packets from the I/O
Manager ASICs to the PICs.
Eight identical synchronous DRAM (SDRAM) dual inline memory modules
(DIMMs)—Form the memory pool shared with the other FPCs installed
in the router.
Parity-protected synchronous SRAM (SSRAM)—Stores data structures used
by the I/O Manager ASICs.
Processor subsystem—Manages packet handling in the FPC and
communication with the SFM. It is a PowerPC 603e-based CPU with
parity-protected DRAM.
EEPROM—Stores the serial number and revision level of the FPC.
Two LEDs—Indicate FPC status. The LED labeled
labeled is red. The LEDs for each FPC are located on the router craft
FAIL
interface. For more information, see "FPC LEDs and Offline Button" on
page 31.
Offline button—Prepares the FPC for removal from the router when pressed.
Like the LEDs, an offline button is located on the craft interface. For more
information, see "FPC LEDs and Offline Button" on page 31.
Four PIC offline buttons (on FPC1 only)—Prepare each corresponding PIC
for removal from the FPC.
Ejector levers—Control the locking system that secures the FPC in the card
cage.
show chassis fpc
is green and the one
OK
command.