Connector Interface Panel (Cip); Table 11: States For Fpc Leds - Juniper Internet Router M160 Hardware Manual

M160 Internet Router Hardware Guide

Table 11: States for FPC LEDs

Label
OK
FAIL

Connector Interface Panel (CIP)

The Connector Interface Panel (CIP) is located at the left side of the FPC card cage,
as shown in Figure 1. It houses Routing Engine management ports and alarm relay
contacts, as shown in Figure 14 and described in the following sections:
32
Connector Interface Panel (CIP)
Color State Description
Green On steadily FPC is functioning normally.
Blinking FPC is starting up or going offline.
Off FPC is offline or not installed.
Red On steadily FPC has failed.
Routing Engine Management Ports on page 33
BITS Input Ports on page 34
Alarm Relay Contacts on page 34