Figure 49: Reinstalling the Rear Upper Impeller Assembly
Figure 50: Reinstalling the Rear Upper Impeller Assembly
Reinstalling the Routing Engines
The router can have a Routing Engine in each of the slots labeled
RE 1
NOTE: If two Routing Engines are installed, they must both be the same version.
To reinstall a Routing Engine, follow this procedure (see Figure 51):
1.
at the rear of the chassis, as shown in Figure 3.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. Make sure the router
is attached to a proper earth ground. For more information about ESD, see
"Preventing Electrostatic Discharge Damage" on page 226.
Installing the Router without a Mechanical Lift
Reinstalling Components into the Chassis
and
RE 0
105