Figure 65: Installing The Cip - Juniper Internet Router M160 Hardware Manual

M160 Internet Router Hardware Guide
CAUTION: Be sure to slide the CIP straight within the slot to avoid damaging the
connector pins on the front of the midplane.
4.
5.
6.

Figure 65: Installing the CIP

144
Replacing the CIP and Routing Engine Interface Port Cables
Using a Phillips screwdriver, tighten the screw at each end of the CIP faceplate.
Reattach an external management device to one of the Routing Engine ports
on the CIP ( ,
AUXILIARY CONSOLE
if desired. For instructions, see "Replacing the Management Ethernet Cable"
on page 146, "Replacing the Console or Auxiliary Cable" on page 146, and
"Replace Alarm Relay Wires" on page 147.
Power on the router and verify correct startup by performing the procedures in
"Powering On the Router" on page 119.
, or ). Also reattach alarm relay contacts
ETHERNET