Figure 82: Installing An Mcs - Juniper Internet Router M160 Hardware Manual

M160 Internet Router Hardware Guide
2.
3.
4.
5.
6.
CAUTION: To maintain proper airflow and provide electromagnetic shielding, do
not operate the router without the rear component cover in place.

Figure 82: Installing an MCS

162
Replacing Host Module Components
Place one hand under the MCS to support it and grasp one of the extractor
clips on the faceplate with the other hand.
Align the rear of the MCS with the guides inside the chassis and slide it
in completely.
Press the extractor clip at each end of the MCS inward.
Verify that the green LED labeled
the host module LEDs on the craft interface to verify that the green LED
labeled is lit for the host module to which the MCS belongs (Figure 11
ONLINE
shows the LEDs).
You can also verify correct MCS functioning by issuing the
show chassis environment mcs
Components on page 131.
Reinstall the rear component cover and tighten the thumbscrew at each corner
to secure it to the chassis. For complete instructions, see "Reinstalling the Rear
Component Cover" on page 109.
S F M 0
S F M 1
M S C 0
R E 0
on the MCS faceplate is lit. Also check
OK
command described in Maintaining Host Module
P C G 0
Extractor clip