Reinstalling The Pcgs; Figure 51: Reinstalling A Routing Engine - Juniper Internet Router M160 Hardware Manual

M160 Internet Router Hardware Guide
2.
3.
4.
CAUTION: Align the Routing Engine carefully with the guide rails and push it in
evenly. Damage can result if it gets lodged in the rails because of uneven movement.
5.
If there is a second Routing Engine, repeat the procedure to reinstall it.

Figure 51: Reinstalling a Routing Engine

Reinstalling the PCGs

The router has two PCGs installed in the slots labeled
at the rear of the chassis, as shown in Figure 3. To reinstall the PCGs,
follow this procedure (see Figure 52):
106
Reinstalling Components into the Chassis
Verify that the extractor clip at each end of the Routing Engine is flipped
toward the outer edge of the unit. If necessary, use your thumbs to push and
hold the red tab on each extractor clip toward the outer edge, then push the
ends of the extractor clips outward.
Place one hand under the Routing Engine to support it and grasp one of the
extractor clips on the faceplate with the other hand.
Align the rear of the Routing Engine with the guide rails inside the chassis
and slide it in completely.
Press the extractor clip at each end of the Routing Engine inward to seat the
unit firmly in the chassis.
S F M 0
S F M 1
M C S 0
R E 0
R E 1
P C G 0
P C G 1
Extractor
clip
and
PCG 0 PCG 1