Installing The Circuit Breaker Box; Figure 99: Removing The Circuit Breaker Box - Juniper Internet Router M160 Hardware Manual

8.
9.
10.

Figure 99: Removing the Circuit Breaker Box

Installing the Circuit Breaker Box

To install the circuit breaker box, follow this procedure (see Figure 100):
1.
2.
3.
4.
5.
6.
Remove the rear lower impeller assembly by loosening the thumbscrew at
each corner and pulling the impeller assembly straight out of the chassis. For
complete instructions, see "Removing the Rear Lower Impeller Assembly"
on page 155.
Using a Phillips screwdriver, loosen and remove the screw at each corner of
the circuit breaker box. Loosen the thumbscrews at the top and bottom
edge of the box.
Pull the circuit breaker box straight out of the chassis.
Verify that there is no power flowing from either external power source, so that
the voltage across the leads of the power cables is 0 V. Ensure that there is no
chance that the cable leads might become active during the procedure.
For each power supply, verify that the power switch on the circuit breaker box
is in the ( ) position.
OFF O
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. Make sure the router
is attached to a proper earth ground. For more information about ESD, see
"Preventing Electrostatic Discharge Damage" on page 226.
Align the guide pin on the back of the circuit breaker box with the opening in
the chassis, then push the circuit breaker box straight in.
Tighten the thumbscrews at the top and bottom edge of the circuit breaker
box. Using a Phillips screwdriver, tighten the screw at each corner of the box.
Slide the power cable lugs for both power sources onto the terminal studs
on the circuit breaker box:
Replacing Hardware Components
Replacing Power System Components
195