Reinstalling The Rear Lower Impeller Assembly; Figure 47: Reinstalling The Fan Tray - Juniper Internet Router M160 Hardware Manual

1.
2.
3.
4.

Figure 47: Reinstalling the Fan Tray

Reinstalling the Rear Lower Impeller Assembly

The rear lower impeller assembly is located to the left of the circuit
breaker box on the rear of the chassis, as shown in Figure 2. To reinstall
it, follow this procedure (see Figure 48):
1.
2.
3.
4.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. Make sure the router
is attached to a proper earth ground. For more information about ESD, see
"Preventing Electrostatic Discharge Damage" on page 226.
Grasp the sides of the fan tray and align the rear of the tray with the guides
inside the chassis.
Slide the fan tray all the way into the chassis.
Tighten the thumbscrew at each end of the cable management system.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. Make sure the router
is attached to a proper earth ground. For more information about ESD, see
"Preventing Electrostatic Discharge Damage" on page 226.
Orient the impeller so that the label is on the top. Align the rails on the upper
edges of the impeller assembly with the guides inside the chassis.
Push the impeller assembly up and to the right to start it into the chassis,
then slide it all the way in.
Tighten the thumbscrew at each corner of the impeller cover.
Installing the Router without a Mechanical Lift
Reinstalling Components into the Chassis
103