Installing The Craft Interface On The Front Impeller Assembly; Figure 72: Removing The Screws Along The Top Front Edge Of The Front Impeller; Figure 73: Removing The Craft Interface - Juniper Internet Router M160 Hardware Manual

Figure 72: Removing the Screws along the Top Front Edge of the Front Impeller Assembly

Figure 73: Removing the Craft Interface

Installing the Craft Interface on the Front Impeller Assembly

To attach the craft interface to the front impeller assembly, follow this procedure:
1.
2.
Top Down View
Upper
impeller
Screws
Craft interface
Hook Window
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. Make sure the router
is attached to a proper earth ground. For more information about ESD, see
"Preventing Electrostatic Discharge Damage" on page 226.
Place the replacement impeller assembly top side up on an antistatic mat on a
flat, stable surface.
Replacing Hardware Components
Replacing Cooling System Components
153