Reinstalling Components Into The Chassis; Figure 44: Installing The Chassis In A Rack - Juniper Internet Router M160 Hardware Manual

10.

Figure 44: Installing the Chassis in a Rack

Reinstalling Components into the Chassis

After you have mounted the chassis in the rack as described in Installing the Chassis
into the Rack on page 97, reinstall the router components into the chassis.
WARNING: The procedures in this section apply only to initial installation and
assume that you have not yet connected power to the router. If power is connected,
completely disconnect it before continuing. See "Disconnecting Power from the
Router" on page 200.
Proceed to the instructions in Reinstalling Components into the Chassis on
page 99.
Center-mounting rack
Chassis
rack-mounting ear
Installing the Router without a Mechanical Lift
Reinstalling Components into the Chassis
99