Changing Parameters; Example - Printronix P5000 Series Setup Manual

Changing Parameters

A configuration consists of several parameters. The default factory
configuration has a starting set of parameters. Your print jobs may require
different parameter settings from the default that is provided. This section
provides an example procedure for changing and saving individual parameter
values.

Example

The following procedure shows how to change and save the settings for the
Unidirectional option. Use these basic guidelines to navigate the configuration
menus and change other parameters.
If you think the configuration for your printer has already been changed from
the default, you should load the default configuration before starting this
procedure (page 63).
OFFLINE
CONFIG.
CONTROL
NOTE: Once you change active emulations, any changes to the previously
Table 4. Parameter Change Example Procedure
Step Key
1. Make sure the printer is on. Raise the printer cover.
2.
ONLINE
3.
+
PRINTER
. . .
CONTROL
Unidirectional
Disable* Enable*
Enable
Disable
selected emulation will be gone unless they have been saved.
Result
OFFLINE
CONFIG. CONTROL
ENTER SWITCH
UNLOCKED
OFFLINE
CONFIG. CONTROL
PMD Fault
Slow Paper
Slew
Disable*
Enable
Notes
Allows you to make configuration
changes.
Example
* = Factory Default
Power Saver
Time
15* - 60 Min.
Instant
55