Starting The Dsp Configurator Program - Extron electronics DTP CrossPoint 108 4K Setup Manual

Starting the DSP Configurator Program

The DSP Configurator can connect to the switcher via any rear
panel LAN port or the front panel Configuration port.
NOTE: Extron recommends connection via an Ethernet LAN
port for the DSP Configurator program.
Start the DSP Configurator program, as follows:
1.
Click
Start > Programs > Extron Electronics > DSP
Configurator > DSP Configurator
Startup screen opens (see figure 22).
Figure 22.
TIP: You can also launch the DSP Configurator program
from within the Product Configuration Software.
2.
Select the DTP CrossPoint switcher in the drop-down menu
and click
OK
TIP: If you have only DTP CrossPoint switchers of the
same model, click
eliminate step 2 in future startups.
The DSP Configurator program starts in Emulate mode (see
figure 23 on page 32).
NOTE:
in the PC and not sent to the switcher until you select Live
mode and "push" the settings to the switcher. See the
DTP CrossPoint 4K Series User Guide.
DSP Configurator Screen and Device Selection
.
Always perform the selected action
In Emulate mode, changes and settings are stored
DTP CrossPoint 4K Series • Remote Control
. The DSP Configurator
to
31