Rogue-Ap Instant-Scan - SMC Networks SMC2890W-AN Management Manual

rogue-ap instant-scan

show rogue-ap
This command starts an immediate scan for access points on the radio interface.
Default Setting
Disabled
Command Mode
Interface Configuration (Wireless)
Command Usage
While the access point scans a channel for rogue APs, wireless clients will not be
able to connect to the access point. Therefore, avoid frequent scanning or scans of
a long duration unless there is a reason to believe that more intensive scanning is
required to find a rogue AP.
Example
AP(if-wireless 0)#rogue-ap scan
AP(if-wireless 0)#
This command displays the current rogue AP configuration and the databases of
known and rogue APs.
Syntax
show rogue-ap <config | table>
config - Displays the current rogue AP configuration.
table - Displays the database of known and rogue APs after scanning.
Command Mode
Exec
Example
AP#show rogue-ap config
Rogue AP Config Information
====================================
Radio 0
Rogue AP scan Status: Enabled
AP Scan Interval : 7200 seconds
AP Scan Duration : 150 milliseconds
AP First Scan Delay : 0 seconds
Radio 1
Rogue AP scan Status: Disabled
AP Scan Interval : 7200 seconds
AP Scan Duration : 150 milliseconds
AP First Scan Delay : 0 seconds
====================================
AP#
Chapter 26
– 245 –
| Rogue AP Detection Commands