SMC Networks SMC2890W-AN Management Manual page 256

Chapter 29
| VLAN Commands
native-vlanid
vlan-id
This command configures the default VLAN ID for the LAN port interface.
Syntax
native-vlanid <vlan-id>
vlan-id - Default VLAN ID. (Range: 1-4094)
Default Setting
1
Command Mode
Global Configuration
Command Usage
◆
To implement the default VLAN ID setting for the LAN port, the AP must first
enable VLAN support using the vlan command.
◆
When VLANs are enabled, the AP assigns the default VLAN ID to untagged
frames received on the LAN port interface.
Example
AP(config)# native-vlanid 123
Warning! VLAN's structure is re-created now !
It will take several seconds !
Please wait a while...
AP(config)#
This command configures the default VLAN ID for the VAP interface.
Syntax
vlan-id <vlan-id>
vlan-id - Default VLAN ID. (Range: 1-4094)
Default Setting
1
Command Mode
Interface Configuration (Wireless-VAP)
Command Usage
◆
To implement the default VLAN ID setting for VAP interface, the access point
must enable VLAN support using the vlan command.
– 256 –