SMC Networks SMC2890W-AN Management Manual page 200

Chapter 23
| Ethernet Interface Commands
dns
ip address
This command specifies the address for the primary or secondary domain name
server to be used for name-to-address resolution.
Syntax
dns {primary-server | secondary-server} <server-address>
primary-server - Primary server used for name resolution.
secondary-server - Secondary server used for name resolution.
server-address - IP address of domain-name server.
Default Setting
None
Command Mode
Global Configuration
Command Usage
The primary and secondary name servers are queried in sequence.
Example
This example specifies two domain-name servers.
AP(if-ethernet)#dns primary-server 192.168.1.55
AP(if-ethernet)#dns secondary-server 10.1.0.55
AP(if-ethernet)#
Related Commands
show interface ethernet
This command sets the IP address for the access point. Use the no form to restore
the default IP address.
Syntax
ip address <ip-address> <netmask> <gateway>
no ip address
ip-address - IP address.
netmask - Network mask for the associated IP subnet. This mask identifies
the host address bits used for routing to specific subnets.
gateway - IP address of the default gateway.
Default Setting
IP address: 192.168.2.10
Netmask: 255.255.255.0
– 200 –