Spanning Tree Commands - SMC Networks SMC2890W-AN Management Manual

21

Spanning Tree Commands

The commands described in this section are used to set the MAC address table
aging time and spanning tree parameters for both the Ethernet and wireless
interfaces.
Table 17: Spanning Tree Commands
Command
bridge stp service
bridge stp br-conf
forwarding-delay
bridge stp br-conf hello-time Configures the spanning tree bridge hello time
bridge stp br-conf max-age
bridge stp br-conf priority
bridge stp port-conf
interface
bridge-link path-cost
bridge-link port-priority
vap
path-cost
port-priority
bridge mac-aging
show bridge stp
show bridge br-conf
show bridge port-conf
show bridge status
show bridge forward address Displays STP settings for forwarding MAC
show bridge mac-aging
Function
Enables the Spanning Tree feature
Configures the spanning tree bridge forward time GC
Configures the spanning tree bridge maximum
age
Configures the spanning tree bridge priority
Enters STP interface configuration mode
Configures the spanning tree path cost for the
Ethernet port
Configures the spanning tree priority for the
Ethernet port
Selects the VAP interface in STP interface
configuration mode
Sets the path cost for a VAP interface in STP
interface configuration mode
Sets the port priority for a VAP interface in STP
interface configuration mode
Sets the MAC address aging time
Displays the global spanning tree settings
Displays spanning tree settings for specified
VLANs
Displays spanning tree settings for specified
interfaces
Displays STP bridge status for a specified VLAN or
all VLANs
addesses on specified interfaces or VLANs
Displays the current MAC address table aging time Exec
– 185 –
Mode Page
GC 186
186
GC 187
GC 187
GC 188
GC 188
IC-E 189
IC-E 189
GC-STP 190
GC-STP 190
GC-STP 191
191
GC
Exec 192
Exec 192
Exec 193
Exec 194
Exec 195
196