Table of Contents
Advertisement
sntp-server timezone
show sntp
◆
Using the command without setting the start and end date enables the
daylight-saving feature.
Example
This sets daylight savings time to be used from the Sunday in the fourth week of
April, to the Sunday in the fourth week of October.
AP(config)# sntp-server daylight-saving date-week 4 4 0 10 4 0
AP(config)#
This command sets the time zone for the access point's internal clock.
Syntax
sntp-server timezone <hours>
hours - Number of hours before/after UTC.
(Range: -12 to +12 hours)
Default Setting
+08 hours (Hong Kong, Perth, Singapore, Taipei)
Command Mode
Global Configuration
Command Usage
This command sets the local time zone relative to the Coordinated Universal Time
(UTC, formerly Greenwich Mean Time or GMT), based on the earth's prime meridian,
zero degrees longitude. To display a time corresponding to your local time, you
must indicate the number of hours and minutes your time zone is east (before) or
west (after) of UTC.
Example
AP(config)#sntp-server timezone +8
AP(config)#
This command displays the current time and configuration settings for the SNTP
client.
Command Mode
Exec
Example
AP#show sntp
Chapter 13
– 147 –
| System Clock Commands
Advertisement
Table of Contents
