SMC Networks SMC2890W-AN Management Manual page 243

Command Mode
Interface Configuration (Wireless)
Command Usage
Enter the MAC address/Basic Service Set Identifier (BSSID) of known APs in the
network. These MAC addresses will be filtered out of the list of detected APs during
a scan. Building a database of approved APs allows the AP to discover rogue APs.
Without a configured database, the AP can detect neighboring APs only, it cannot
identify whether the APs are rogues.
Example
rogue-ap delete
This command removes MAC addresses from the database of known APs.
friendly
Syntax
Default Setting
None
Command Mode
Interface Configuration (Wireless)
Example
rogue-ap duration
This command sets the scan duration for detecting access points.
Syntax
Default Setting
150 milliseconds
AP(if-wireless 0)#rogue-ap add friendly 00-12-34-56-78-9a
AP(if-wireless 0)#
rogue-ap delete friendly <mac-address | all>
mac-address - Removes the specified MAC address.
all - Removes all AP MAC address from the database.
AP(if-wireless 0)#rogue-ap delete friendly 00-12-34-56-78-9a
AP(if-wireless 0)#
rogue-ap duration <milliseconds>
milliseconds - The duration of the scan. (Range: 10-150 milliseconds)
– 243 –
Chapter 26
| Rogue AP Detection Commands