Table of Contents
Advertisement
bridge stp br-conf
Use this command to configure the spanning tree bridge hello time globally for the
hello-time
wireless bridge.
Syntax
Default Setting
2 seconds
Command Mode
Global Configuration
Command Usage
This command sets the time interval (in seconds) at which the root device transmits
a configuration message.
Example
bridge stp br-conf
Use this command to configure the spanning tree bridge maximum age globally
max-age
for the wireless bridge.
Syntax
Default Setting
20 seconds
Command Mode
Global Configuration
Command Usage
This command sets the maximum time (in seconds) a device can wait without
receiving a configuration message before attempting to reconfigure. All device
ports (except for designated ports) should receive configuration messages at
regular intervals. Any port that ages out STP information (provided in the last
configuration message) becomes the designated port for the attached LAN. If it is a
bridge stp br-conf hello-time <time>
time - Time in seconds. (Range: 1-10 seconds).
The maximum value is the lower of 10 or [(max-age / 2) -1].
AP(config)#bridge stp br-conf hello-time 5
AP(config)#
bridge stp br-conf max-age <seconds>
seconds - Time in seconds. (Range: 6-40 seconds)
The minimum value is the higher of 6 or [2 x (hello-time + 1)].
The maximum value is the lower of 40 or [2 x (forward-time - 1)].
– 187 –
Chapter 21
| Spanning Tree Commands
Advertisement
Table of Contents
