Step 4; Figure 8: Quick Start - Step 4 - SMC Networks SMC2890W-AN Management Manual

Chapter 2
| Initial Configuration
Web Quick Start

Step 4

Authentication
◆
802.1X — The access point supports 802.1X authentication only for clients
initiating the 802.1X authentication process (i.e., the access point does not
initiate 802.1X authentication). For clients initiating 802.1X, only those
successfully authenticated are allowed to access the network. For those clients
not initiating 802.1X, access to the network is allowed after successful wireless
association with the access point. The 802.1X mode allows access for clients not
using WPA or WPA2 security.
◆
Pre-Authentication — When using WPA2 over 802.1X, pre-authentication can
be enabled, which allows clients to roam to a new access point and be quickly
associated without performing full 802.1X authentication. (Default: Disabled)
◆
802.1x Reauthentication Time — The time period after which a connected
client must be re-authenticated. During the re-authentication process of
verifying the client's credentials on the RADIUS server, the client remains
connected the network. Only if re-authentication fails is network access
blocked. (Range: 0-65535 seconds; Default: 0 means disabled)
Note: When 802.1X is enabled, be sure to configure RADIUS server details. For
more information, see "RADIUS Settings" on page
When you have clicked "Set" after Step 3, the AP saves the Quick Start configuration
settings. Click "OK" to confirm that the Quick Start is complete.

Figure 8: Quick Start - Step 4

– 31 –
37.