Table of Contents
Advertisement
Chapter 15
| SNMP Commands
snmp-server target
username - Name of the user connecting to the SNMP agent. (Range: 1-32
characters)
groupname - Name of an SNMP group to which the user is assigned. (Range:
1-32 characters)
none | md5 - Uses no authentication or MD5 authentication.
auth-passphrase - Authentication password. Enter a minimum of eight
characters for the user. (8 – 32 characters)
none | des - Uses SNMPv3 with no privacy, or with DES56 encryption.
priv-passphrase - Privacy password. Enter a minimum of eight characters for
the user. (8 – 32 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆
Multiple SNMPv3 users can be configured on the access point.
◆
Users must be assigned to groups that have the same security levels. If a user
who has "AuthPriv" security (uses authentication and encryption) is assigned to
a NoAuthNoPriv group, the user will not be able to access the database. An
AuthPriv user must be assigned to the group with the AuthPriv security level.
Example
AP(config)#snmp-server user chris grname md5 passw1 des passw2
AP(config)#
This command configures SNMP v3 notification targets. Use the no form to delete
an SNMP v3 target.
Syntax
snmp-server target <target-id> <ip-addr> <sec-name> <port-number>
[notification-filter-id]
no snmp-server target <target-id>
target-id - A user-defined name that identifies a receiver of SNMP
notifications. (Maximum length: 32 characters)
ip-addr - Specifies the IP address of the management station to receive
notifications.
sec-name - The defined SNMP v3 user name that is to receive notifications.
– 158 –
Advertisement
Table of Contents
