Interface Wireless - SMC Networks SMC2890W-AN Management Manual

Table 20: Wireless Interface Commands (Continued)
Command
assoc- timeout-interval
auth- timeout-value
multicast-enhance
shutdown
interfere-chan-recover
antenna-chain
long-distance
long-distance reference-
data
long-distance slottime
long-distance
acktimeout
long-distance
ctstimeout
bandwidth-control
downlink
bandwidth-control
downlink rate
bandwidth-control
uplink
bandwidth-control
uplink rate
show interface wireless
show station
show station statistics

interface wireless

This command enters wireless interface configuration mode.
Syntax
Default Setting
None
Function
Configures the idle time interval (when no frames
are sent) after which a client is disassociated from
the VAP interface
Configures the time interval after which clients
must be re-authenticated
Enhances multicast quality for wireless clients
Disables the wireless interface
Rescans channels when interference is detected
Sets the internal antennas to use
Enables long distance parameter settings
Computes settings from a distance reference
Sets the slot time parameter
Sets the acknowledge timeout parameter
Sets the CTS timeout parameter
Enables downlink bandwidth control on a VAP
interface
Sets the downlink bandwidth rate for a VAP
interface
Enables uplink bandwidth control on a VAP
interface
Sets the uplink bandwidth rate for a VAP interface
Shows the status for the wireless interface
Shows the wireless clients associated with the
access point
Shows traffic statistics for wireless clients associated
with the access point
interface wireless <index>
index - The index of the wireless interface. (Range: 0 or 1, where "0" is the
2.4 GHz interface and "1" the 5 GHz interface)
– 207 –
Chapter 24
| Wireless Interface Commands
Mode Page
IC-W-VAP 219
IC-W-VAP 220
IC-W-VAP 220
IC-W-VAP 221
IC-W 221
222
IC-W
IC-W 222
IC-W 223
IC-W 223
IC-W 224
IC-W 224
IC-W-VAP 225
IC-W-VAP 225
IC-W-VAP 226
IC-W-VAP 226
Exec 227
228
Exec
Exec 229