SMC Networks SMC2890W-AN Management Manual page 154

Chapter 15
| SNMP Commands
snmp-server host
Command Mode
Global Configuration
Command Usage
◆
This command enables both authentication failure notifications and link-up-
down notifications.
◆
The snmp-server host command specifies the host device that will receive
SNMP notifications.
Example
AP(config)#snmp-server enable server
AP(config)#
Related Commands
snmp-server host
This command specifies the recipient of an SNMP notification. Use the no form to
remove the specified host.
Syntax
snmp-server host <host_ip_address> <community-string>
no snmp-server host
host_ip_address - IP of the host (the targeted recipient).
community-string - Password-like community string sent with the
notification operation. (Maximum length: 23 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆
The snmp-server host command is used in conjunction with the snmp-server
enable server command to enable SNMP notifications. You can configure up
to four host IP addresses. A separate snmp-server host command must be
entered for each host.
◆
Although you can set the community string using the snmp-server host
command by itself, it is recommended that you define this string using the
snmp-server community command prior to using the snmp-server host
command.
– 154 –