Table of Contents
Advertisement
Chapter 15
| SNMP Commands
snmp-server vacm
group
include - Defines a filter type that includes objects in the MIB subtree.
exclude - Defines a filter type that excludes objects in the MIB subtree.
subtree - The part of the MIB subtree that is to be filtered.
mask - An optional hexadecimal value bit mask to define objects in the MIB
subtree.
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆
The access point allows multiple notification filters to be created. Each filter can
be defined by up to 20 MIB subtree ID entries.
◆
Use the command more than once with the same filter ID to build a filter that
includes or excludes multiple MIB objects. Note that the filter entries are
applied in the sequence that they are defined.
◆
The MIB subtree must be defined in the form ".1.3.6.1" and always start with a ". " .
◆
The mask is a hexadecimal value with each bit masking the corresponding ID in
the MIB subtree. A "1" in the mask indicates an exact match and a "0" indicates a
"wild card. " For example, a mask value of 0xFFBF provides a bit mask "1111 1111
1011 1111. " If applied to the subtree 1.3.6.1.2.1.2.2.1.1.23, the zero corresponds
to the 10th subtree ID. When there are more subtree IDs than bits in the mask,
the mask is padded with ones.
Example
AP(config)#snmp-server vacm view testview include .1
AP(config)#snmp-server vacm view testview exclude .1.3.6.1.2.1.2.2.1.1.23
This command configures SNMP v3 groups. Use the no form to delete an SNMP v3
group.
Syntax
snmp-server vacm group <name> {security-level <level>} <read-view>
<write-view>
no snmp-server vacm group <name>
name - A user-defined name that identifies an SNMP v3 group. (Maximum
length: 32 characters)
– 156 –
Advertisement
Table of Contents
