SMC Networks SMC2890W-AN Management Manual page 253

Command Usage
◆
The transmit delay is used to prevent a series of successive LLDP transmissions
during a short period of rapid changes in local LLDP MIB objects, and to
increase the probability that multiple, rather than single changes, are reported
in each transmission.
◆
This attribute must comply with the rule: (4 * Delay Interval) ≤ Transmission
Interval
Example
AP(config)# lldp transmit delay-to-local-change 10
txDelay range is 1 to quter of msgTxInterval
AP(config)#
show lldp
This command displays the current LLDP configuration.
Command Mode
Exec
Example
AP# show lldp
LLDP Information
===================================================================
Status
Message Transmission Hold Time
Message Transmission Interval (seconds) :30
Reinitial Delay Time (seconds)
Transmission Delay Value (seconds)
===================================================================
AP#
Chapter 28
:Enabled
:5
:2
:2
– 253 –
| Link Layer Discovery Commands