Table of Contents
Advertisement
Chapter 24
| Wireless Interface Commands
antenna-chain
long-distance
This command selects the use of two antennas or a single antenna for radio
transmissions.
Syntax
antenna-chain <right-left | left | right>
right-left - The radio transmits from both internal antennas.
left - The radio only transmits from one internal antenna.
right - The radio only transmits from one internal antenna.
Default Setting
right-left
Command Mode
Interface Configuration (Wireless)
Example
AP(if-wireless 0)# antenna-chain left
This setting has not been effective !
If want to take effect, please execute make-RF-setting-effective command !
AP(if-wireless 0)#
This command computes settings that allow wireless clients a long distance from
the AP to maintain communications.
Syntax
long-distance <enable | disable>
enable - Enables the long distance settings.
disable - Disables the feature.
Default
Disabled
Command Mode
Interface Configuration (Wireless)
Command Usage
When you have long-distance links in the wireless network, some timing
parameters require an adjustment to maintain communications. You can enable
this feature and then use the
settings based on an approximate distance.
long-distance reference-data
– 222 –
command to suggest
Advertisement
Table of Contents
