SMC Networks SMC2890W-AN Management Manual page 227

Command Mode
Interface Configuration (Wireless-VAP)
Example
AP(if-wireless 0: VAP[0])# bandwidth-control uplink rate 512
This setting has not been effective !
If want to take effect, please execute make-security-effective command !
AP(if-wireless 0: VAP[0])#
show interface
This command displays the status for a specified VAP interface.
wireless
Syntax
show interface wireless <index> vap <vap-index>
Command Mode
Exec
Example
AP# show interface wireless 0 vap 0
----------------------------------Basic Setting----------------------------
SSID
Wireless Network Mode
Auto Channel Select
Channel
High Throughput Mode
Status
VLAN-ID
Dhcp-Relay Server Ip
------------------------------------Capacity--------------------------------
Maximum Association Client Per Vap
Maximum Association Client Per Radio
--------------------------------802.11 Parameters---------------------------
Transmit Power
Preamble Length
Fragmentation Threshold
RTS Threshold
Beacon Interval
Authentication Timeout Interval
Association Timeout Interval
DTIM Interval
Short Guard Interval Status
A-MPDU Status
A-MPDU Length Limit
A-MSDU Status
------------------------------------Security--------------------------------
Closed System
index - The wireless interface slot number. (Range: 0 or 1)
vap-index - The number that identifies a VAP interface.
(Options: 0-15)
– 227 –
Chapter 24
| Wireless Interface Commands
: EAP9112A_11BGN_0
: 11ng
: DISABLE
: 6
: HT20
: ENABLE
: 1
: 0.0.0.0
: 16 Clients
: 127 Clients
: 100%(20 dBm)
: Short-or-Long
: 2346
: 2346
: 100
: 3 Mins
: 5 Mins
: 1
: Disabled
: Enabled
: 65535 Bytes
: Enabled
: DISABLE