Figure 6: Quick Start - Step 2 - SMC Networks SMC2890W-AN Management Manual

Caution: You must set the country code to the country of operation. Setting the
country code restricts operation of the access point to the radio channels and
transmit power levels permitted for wireless networks in the specified country.
◆
Cancel — Cancels the newly entered settings and restores the orignals.
◆
Next — Proceeds to the next page.
Step 2
The Step 2 page of the Quick Start configures IP settings and DHCP client status.

Figure 6: Quick Start - Step 2

The following items are displayed on this page:
DHCP
◆
DHCP Status — Enables/disables DHCP on the access point. (Default: Disabled)
◆
IP Address — Specifies an IP address for the access point. Valid IP addresses
consist of four decimal numbers, 0 to 255, separated by periods. (Default:
192.168.2.10.)
◆
Subnet Mask — Indicates the local subnet mask. Select the desired mask from
the drop down menu. (Default: 255.255.255.0)
◆
Default Gateway — The default gateway is the IP address of the router for the
access point, which is used if the requested destination address is not on the
local subnet. (Default: 192.168.2.254)
If you have DNS, RADIUS, or other network servers located on another subnet,
type the IP address of the default gateway router in the text field provided.
– 28 –
Chapter 2
| Initial Configuration
Web Quick Start