HP STORAGEWORKS SSL1016 Reference Manual page 43

To set the SCSI ID:
1. On the main menu, scroll to Configuration.
Figure 19: Main menu
2. Press Enter.
3. On the Configuration submenu, scroll to SCSI ID.
Figure 20: Select SCSI ID
4. Press Enter.
5. Scroll to the number you want to set as the autoloader SCSI ID.
Figure 21: Set SCSI ID
6. Press Enter.
7. Reboot for the new SCSI ID to take affect.
The new SCSI ID is now in effect.
SSL1016 Tape Autoloader Reference Guide
Status
Commands
Configuration
Diagnostics
SCSI ID
Ethernet
Time
Change Mode
to change
Enter to continue
SCSI ID: 05
a. Press and hold the power button on the front panel until Power Off
appears on the LCD.
b. Press the power button again to power on the autoloader.
Installation and Configuration
43