Error Messages - HP STORAGEWORKS SSL1016 Reference Manual

Table 13: Suggested Actions for Operational Problems
Autoloader does not
power up.

Error Messages

Failures can occur while operating the autoloader. They prevent the autoloader
from completing a specific action. When a failure occurs, two things can happen:
SSL1016 Tape Autoloader Reference Guide
Problem
No error message appears, but the autoloader fails to complete the action. If
no message appears, you will need to call a service representative to
troubleshoot the problem.
An error message appears on the front panel or Web Administration. If an
error message appears, follow the procedures listed in
resolve the problem.
Probable Cause
The power cord or
source is
malfunctioning or the
autoloader is incorrectly
configured.
The power switch on the
back of the autoloader
is set to 0.
The DCA is not fully
seated.
Troubleshooting
Suggested Action
Check all outlets and power
cords for proper connection.
Flip the power switch on the
back of the autoloader back
to the | position and, if
necessary, press the power
button on the front of the
autoloader.
Reseat the DCA to ensure a
good connection to the
chassis assembly.
Table 14 to try and
129