Removing The Autoloader From The Rack; Standalone Installation; Preparation - HP STORAGEWORKS SSL1016 Reference Manual
Tape autoloader
Hide thumbs
Also See for STORAGEWORKS SSL1016:
- Quickspecs (12 pages) ,
- Technical specifications (4 pages) ,
- Installation instructions (2 pages)
Table of Contents
Advertisement
Installation and Configuration
Removing the Autoloader From the Rack
When removing the autoloader from the rack:
Standalone Installation
Use these instructions if you will not be installing your autoloader into a rack.
Preparation
To prepare your autoloader for standalone installation:
1. Place one rear standalone leg into place and secure with two screws. Repeat
Figure 14: Installing the rear standalone leg
34
Always use at least two people.
Install the optional installation brackets if there is no device installed below
the autoloader.
Before powering off the autoloader, remove the magazines.
for the other side.
SSL1016 Tape Autoloader Reference Guide
Advertisement
Table of Contents
