Figure 17: Connecting the power cord
Note:
To power on the autoloader:
1. Push the power switch that is on the back of the autoloader to the on position
Note:
the On/Off button on the front of the autoloader.
SSL1016 Tape Autoloader Reference Guide
Do not power on the host before powering on the autoloader.
(the | is pressed).
Wait while the autoloader performs its power-on sequence. During this time,
the following activities occur:
The cooling fans begin to operate.
The LCD illuminates and displays power-on messages.
The autoloader performs a power-on self-test (POST).
The autoloader performs a calibration and magazine element status.
Depending on how the autoloader was last powered off, you may need to press
Installation and Configuration
39