Installation and Configuration
SCSI Connection
The SCSI connection lets the host computer communicate with the autoloader.
Note:
host computer, install one before proceeding.
To make the SCSI connection:
1. If the host computer is connected to a network, check with the system
2. Properly power off all peripheral devices connected to the host computer.
3. Power off the host computer.
4. Install the supplied 68-pin 6 foot (1.83 meter) SCSI cable to the
Note:
36
If you do not already have a compatible and available SCSI HBA installed in the
Caution:
When installing cables, be careful not to damage the SCSI pins on
the connectors. Damaged pins will cause the connection to fail.
administrator before turning off power.
double-stacked SCSI connector that is on the back of the DCA and tighten the
screws. You can install the SCSI cable in either port.
Use an appropriate cable that matches your host connector.
SSL1016 Tape Autoloader Reference Guide