Set Ethernet Configurations - HP STORAGEWORKS SSL1016 Reference Manual

Set Ethernet Configurations

When you originally installed the autoloader, you set the Ethernet connections
through the front panel. However, you can change them through the Web
Administration tool.
To change the Ethernet configurations:
1. On any Web Administration page, click Configurations.
2. On the secondary menu, click Networking.
Figure 86: Networking options
3. If a checkmark appears in the box next to DHCP, the dynamic IP address
4. If no checkmark appears in the box next to DHCP, the permanent IP address
SSL1016 Tape Autoloader Reference Guide
The current settings appear on the screen.
option is enabled. To set a permanent IP address:
a. Click the box to remove the checkmark.
b. In the IP address fields, type in the new address, using your Tab key to
move from box to box.
option is enabled. To change a permanent IP address, in the IP address fields,
type in the new address, using your Tab key to move from box to box.
Autoloader Operation
113