D Upgrading Or Replacing The Dca; Configuration And Tools; Removing A Dca - HP STORAGEWORKS SSL1016 Reference Manual

Upgrading or Replacing the
DCA
This appendix describes how to upgrade or replace the drive carrier assembly
(DCA).

Configuration and Tools

If you replace or upgrade the autoloader DCA, you need to check settings for the
DCA and the SCSI bus.
You will need a Phillips screwdriver to replace a DCA.

Removing a DCA

Before you replace the autoloader DCA, you must make sure the tape drive does
not contain a cartridge. To unload a tape from the tape drive, see "Move a Single
Cartridge" or "Eject a Single Cartridge" in Chapter 4.
You must also turn off power to the autoloader and disconnect the power and SCSI
cables from the back of the DCA.
SSL1016 Tape Autoloader Reference Guide
Caution: The DCA contains electronic sensitive components. Be sure to wear
your wrist ground strap whenever handling the DCA.
D
151