25.1 Overview
Remote management allows you to determine which services/protocols can access which Device
interface (if any) from which computers.
The following figure shows remote management of the Device coming in from the WAN.
Figure 141 Remote Management From the WAN
Note: When you configure remote management to allow management from the WAN, you
still need to configure a IP filter rule to allow access.
You may manage your Device from a remote location via:
• Internet (WAN only)
• LAN only
• LAN and WAN
• None (Disable)
To disable remote management of a service, select Disable in the corresponding Service Access
field.
25.1.1 What You Can Do in the Remote Management Screens
• Use the WWW screen
from which IP addresses users can use HTTP to manage the Device.
• Use the Telnet screen
from which IP addresses users can use Telnet to manage the Device.
• Use the FTP screen
which IP addresses users can use FTP to access the Device.
VMG1312-T10C User's Guide
LAN
(Section 25.2 on page
(Section 25.3 on page
(Section 25.4 on page
C
HAPTER
Remote Management
WAN
HTTP
Telnet
206) to configure through which interfaces and
208) to configure through which interfaces and
209) to configure through which interfaces and from
2 5
205