Attach the finisher connector cable to the rear
17
of the printer as shown.
18
Align the finisher with the printer so they can
be connected together. Align the pins on the
left hand edge of the Paper Transport with the
holes on the top edge of the Transport Cover.
Be careful of metal plate edges at the
base of the finisher as you complete the
installation.
19
Insert the thumb screw into the hole at the end
of the Guide Rail at the base of the finisher and
hand tighten it as shown.
20
Then push the finisher against the printer.
Make sure the pins on the Paper Transport are
firmly seated into the Transport Cover.
21
Lock the rear wheels on the finisher.
Chapter 6: Installing and Removing Printer Options
Finisher
6-57